10/31/2023 0 Comments Ramps 1.4 usb 2.0 serial driver![]() ![]() Also, the heat bed FET is hooked directly to my heat bed without an external FET. They easily deliver 2 amps to the z stepper and the chip runs only slightly warm. For the z-axis I used two steppers with an adapter board I got from Zyltech that let’s you plug 2 steppers in parallel. I did not need to install any drivers, Win10 recognized it as a serial port, which runs at 250K baud. I programmed it via Arduino on my PC (Win10). ![]() I built a 3d printer using the MKS Gen L V1 board.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |